Connectivity Test troubleshooting

If a connectivity test fails, check the possible causes below:

HTTP test

• The ARgon Server requires that firewalls allow HTTP and HTTPS traffic outbound to the applianceupdate.clearswift.com address. Check the settings for any company firewalls between the ARgon Server and the Internet to ensure that this traffic is allowed.
• Check that the HTTP proxy settings are correct. See Managing HTTP Proxy Settings for more information.

• Check the configuration of any static routes that have been configured. See Network configuration for more information.

SMTP & Relay To test

• Check that you entered the correct IP address and port number for the SMTP servers. See Specifying Routing of Email for more information.
• Check that your SMTP servers are running.
• Check the settings on your company firewall between the ARgon Server and the SMTP servers. Firewalls must allow SMTP traffic from the ARgon Server to the SMTP server on the defined port number.
• Check if the SMTP server has been configured to block SMTP connections from the IP address of the ARgon Server. This will cause the test to fail.

• Check the configuration of any static routes that have been configured. See Network configuration for more information.

Backup test

• Check that you have configured the correct details for the FTP server. See Backing up the System for more information.
• Check the settings on your company firewall between the ARgon Server and the FTP server. Firewalls must allow SMTP traffic from the ARgon Server to the FTP server on the defined port number. See Firewall Ports for more information.
• Check the configuration of any static routes that have been configured. See Network configuration for more information.

• Check the configuration of any static routes that have been configured. See Network configuration for more information.