Disabling or Enabling a Policy Route

Clearswift Gateway only uses enabled policy routes when applying content security policy to traffic or messages.

If you want temporarily to stop Clearswift Gateway using a particular policy route, you can disable the policy route. Re-enable the route when you want Clearswift Gateway to use the route again.

To disable or enable a policy route:

  1. Click Policy > Mail Policy Routes (Email) or Web Policy Routes (Web).
  2. Select a policy route.
  3. Click Disable or Enable.
  4. Apply the configuration.
 

References to Web policy content are only available when a Web Gateway is included in the peer group.

See also...