The Unacceptable Images clause is a What To Look For? clause in the Detect Unacceptable Images content rule, which looks for unacceptable images, based on a user-specified threshold.
ImageLogic rates the acceptability of each image it scans by assigning it a score based on its content. Higher scores are considered to be less acceptable than lower scores. Images scoring higher than the threshold value you've set are considered unacceptable and the appropriate action (typically quarantine) is applied by the content rule.
To define the clause:
- Open the editing page for the Detect Unacceptable Images content rule.
- Beside the Unacceptable Images clause in the What To Look For? area of the content rule, click Click here to change these settings.
- Click the appropriate radio button to either:
- Use the default threshold of 46.
- Enter a threshold of (user-defined value between 1 and 100).
The ImageLogic threshold change only applies to this specific content rule.
- Click Save.
-
Apply the configuration.
| Raising the threshold reduces the possibility of false positives, such as images containing flesh tones (but not full or partial nudity). Be aware that the default threshold value may change automatically during a system update, as the behavior of ImageLogic is refined. |
For more information about classifying images in ImageLogic, refer to ImageLogic.
|
If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information. If you use |