Hosted Domains

In Secure Email Gateway, you need to specify the list of email domains used by your organization. The Gateway uses this list when determining whether to accept incoming email messages. To be accepted, a message must contain a "To" address with a domain listed in the hosted domains list.

Add a hosted domain

  1. Navigate to System > SMTP Settings > Mail Domains and Routing. The Mail Domains and Routing page is displayed.
  2. Select the Hosted Domains tab. A list of the current hosted domains are displayed.
  3. Click New. The New Hosted Domain dialog is displayed.
  4. In the Domain field, enter a fully qualified domain name (FQDN).
  5. Click Add. The new domain is added to the list.
  6. Apply the configuration.
  If you are configuring mail domains for a Domain Controller, you should add your hosted domains to this list and add a Domain Controller using the PMM Authenticaion Settings page.

Edit a hosted domain

  1. Navigate to System > SMTP Settings > Mail Domains and Routing. The Mail Domains and Routing page is displayed.
  2. Select the Hosted Domains tab. A list of the current hosted domains are displayed.
  3. Select the domain you wish to edit and click Edit. The Edit Hosted Domains dialog is displayed.

  4. Select the Hosted Domain tab.

  5. Modify the domain's fully qualified domain name (FQDN) and click Update.

  6. Apply the configuration.

 

If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information.

If you use Peer Gateways (i.e. when multiple Gateways are peered), any configuration changes from a local Gateway can then be applied to all the peers at the same time. See Configure Peer Gateways for more information.