You can set the Browsing Time Policy for your Clearswift Gateway .
To specify the Browsing Time Policy:
- From the Policy Center Home page, click Global Web Policy. The Global Web Policy page appears.
- Move the mouse pointer over the Browsing Time Policy section and click Click here to change these settings.
- By default, Clearswift Gateway makes the following assumptions about the Browsing Time:
- A user will take a maximum of 120 seconds to read a page before moving to the next. You can enter a new value between 2 and 600 seconds. If you enter a lower or higher value, the Save icon becomes disabled.
-
If a user overrides a block page allow an additional 10 minutes browsing time. You can enter a new value between 5 and 60 minutes. If you enter a lower or higher value, the Save icon becomes disabled.
This is the value referred to as a 'short time' by the block page encountered by the user:
You can continue browsing for a short time.
- If enabled by specifying the default action to be performed on requests and responses on the route (see Editing A Policy Route), the user will be shown a warning page when their browsing quota has 10 minutes left. You can enter a new value between 5 and 60 minutes. If you enter a lower or higher value, the Save icon becomes disabled.
- Click Save.
- Apply the configuration.