Ethernet Settings
The network settings displayed on the Ethernet Settings page describe the way your
Only IPv4 addresses are valid for use within the UI service. Link Local addresses are not supported. |
Select an IP Address for the UI Service
To select the IP address of the UI service:
- Navigate to System > System Settings > Ethernet Settings. The Ethernet Settings page is displayed.
-
In the task panel:
- Click Change IP Address for the UI Service to specify the primary IP address
- Click Change Secondary IP Address for the UI Service to specify the secondary IP address
- Select an alternative IP address from the drop-down menu.
If you attempt to change the IP address for the UI service and you receive the warning that there are no un-allocated IP addresses, you must first define addresses in Red Hat Cockpit. |
Network Adapters
Use the Networking page in Red Hat Cockpit to configure network adapters.
If you are using Cockpit to configure multiple network adapters, note that each adapter must operate on a different subnet. |