If one Server goes down, you lose any transactions in progress until the failover goes online.
After you Set Up the Server Cluster, Set Up EFT Servers to Run in a Clustered Environment, and Integrated EFT Server into the Cluster, you should have both nodes configured with shared resources, including a shared IP address, disk array, quorum, and two EFT Servers. Perform tests to ensure the system was correctly configured.
Go to each node and switch groups, which will set one node or the other as active.
Unplug one of the nodes from the UPS and verify that the switchover takes place (usually < 30 seconds before the failover takes control).
Your cluster setup is now complete.
|
|
If one Server goes down, you lose any transactions in progress until the failover goes online. |