Enabling and Disabling Commands

You can enable and disable Commands as needed, without deleting them.

To enable or disable a Command

  1. In the administration interface, connect to EFT and click the Server tab.

  2. On the Server tab, expand the Site node for the Site that you want to configure, click Commands, and then click a Command in the tree. The Command's definition appears in the right pane on the Command Settings tab.

    When you create a new Command, the Enable this command check box is selected on the Command Settings tab.

  3. To disable the Command, clear the Enable this command check box, and then click Apply. When the Command is disabled, an x within a red circle appears over the Command's icon.