Adding a Local Console Action

The display allows to add a new action to the selected sub-console.

NOTE: The same parameters are used on this display whenever you use option 2=Change from the Change Console Actions display.

Parameters on the Add Local Console Action Display

The following parameters are available on the Add Local Console Action display.

Console

Displays the name of the sub-console for which the added action will apply.

Action Sequence

Enter the sequence number for this action. Retain the current action sequence number to add an action to the same sequence. All actions with the same sequence number must have the same count.

Action type

Specifies the action to be performed. Type the name of a pre-defined action, a user defined action template, or use F4=Prompt to select from a list of applicable actions or action templates.

If an action template is specified, a COMMAND action is created, preset with the command defined in the action template.

NOTE: See Adding Actions to Rules for detailed explanations of each possible action entry in this parameter.

Once the actions have been added in the required sequence order, press Enter to confirm and return to the Change Console Actions display.

The following functions are available on the Add Local Console display.

F3=Exit

Use F3=Exit to close the current display and return to the main menu.

F5=Refresh

Use F5=Refresh to update the display with current information.

F4=Prompt

Use F4=Prompt, where applicable, to open a list of valid alternatives from which a selection can be made.

F12=Cancel

Use F12=Cancel to exit this display and return to the previous display.