Real-time IP Blocklist Servers

You can add, modify, or delete other RBL (real-time blocklist) servers as required.

See About Real-time IP Blocklists for more information about RBLs.

 

Changing these settings without good reason can adversely affect spam detection rates. You should normally only perform these actions on the advice of your normal support provider.

We recommend using your own DNS servers for RBL spam detection, as a public DNS can also adversely affect detection rates.

Add, edit, or delete RBL servers

  1. Navigate to Policy > Manage Policy Definition > SpamLogic Settings. The SpamLogic Settings page is displayed.

  2. Select the Parameters tab.

  3. In the Real-time IP Blocklist Servers panel, click Click here to change these settings.

  4. Add, edit, or remove RBL servers as required. You can specify up to five RBL servers.

  5. Click Save.

 

If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information.

If you use Peer Gateways (i.e. when multiple Gateways are peered), any configuration changes from a local Gateway can then be applied to all the peers at the same time. See Configure Peer Gateways for more information.