Configure Validate Sender Domain

You can reject messages that use invalid sending email addresses.

Enable or disable sender domain validation

  1. Navigate to Policy > Manage Policy Definition > SpamLogic Settings. The SpamLogic Settings page is displayed.

  2. Select the Spam Policy tab.

  3. In the Spam Policy panel, click Click here to change these settings.

  4. From the drop-down menu of Validate Sender Domain, select:

    • Disabled

    • Reject

  5. Click Save.

 

If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information.

If you use Peer Gateways (i.e. when multiple Gateways are peered), any configuration changes from a local Gateway can then be applied to all the peers at the same time. See Configure Peer Gateways for more information.

See also...