Disable or enable a policy route

Policy routes must be enabled to detect and match messages. Secure Email Gateway does not apply content security policy to messages on disabled policy routes.

If you wish to temporarily stop the Gateway from using a particular policy route, disable it rather than deleting, and re-enable the route when required.

On the Manage Policy Routes page, symbols for disabled policy routes are gray, for example, and , whereas enabled policy routes have colored symbols, such as and .

Disable or enable a policy route

1. Navigate to Policy > Manage Policy Definition > Mail Policy Routes. The Manage Policy Routes page is displayed, listing the existing policy routes.

2. Select the policy route and click Enable or Disable, as required.

3. Apply the configuration.

If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information. If you use Peer Gateways (i.e. when multiple Gateways are peered), any configuration changes from a local Gateway can then be applied to all the peers at the same time. See Peer Gateways for more information.