BATV Address Validation parameters

The Advanced BATVClosed Bounce Address Tag Validation Address Validation Settings enable you to change the pass-phrase that uniquely identifies your mail domain. This will be required when you have more than one Gateway serving your company mail network but these Gateways are not part of a peer group. In this case, you need to set the same pass-phrase on each Gateway manually.

See BATV for more information.

  A random pass-phrase was generated at installation.

Configure BATV Address Validation settings

  1. Navigate to Policy > Manage Policy Definition > SpamLogic Settings. The SpamLogic Settings page is displayed.

  2. Select the Parameters tab.

  3. In the BATV Address Validation panel, click Click here to change these settings.

  4. In the Passphrase field, enter a passphrase to uniquely identify your mail domain.

  5. In the Confirm field, re-enter the passphrase.

  6. Click Save.

 

If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information.

If you use Peer Gateways (i.e. when multiple Gateways are peered), any configuration changes from a local Gateway can then be applied to all the peers at the same time. See Peer Gateways for more information.