Configure Spoof Detection

You can reject messages from outside your organization that has a forged sender with an internal email address.

Configure Spoof Detection

  1. Navigate to Policy > Manage Policy Definition > SpamLogic Settings. The SpamLogic Settings page is displayed.

  2. Select the Spam Policy tab.

  3. In the Spam Policy panel, click Click here to change these settings.

  4. From the drop-down menu of Spoof Detection, select:

    • Disabled

    • Hold in area

    • Reject

      If you select an option that contains Hold, a message will be held in a message area specified in the Hold Junk Email in Message Area panel on the SpamLogic Settings page.

  5. Click Save.

 

  • To avoid messages from trusted sources being blocked by Spoof Detection, add them to an Allow List.

  • If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information.

  • If you use Peer Gateways (i.e. when multiple Gateways are peered), any configuration changes from a local Gateway can then be applied to all the peers at the same time. See Peer Gateways for more information.

See also...