If you configure the Alert Settings, Secure Email Gateway generates an email alert message to a specified recipient when it performs the Generate an alert action in a content rule.
Configure Alert Settings
- Navigate to System > Gateway Settings > Policy Engine Settings. The Policy Engine Settings page is displayed.
- In the Alert Settings panel, click Click here to change these settings.
-
Specify the Sender, Recipient and Subject for email alert messages. Note that you may only specify one recipient.
Tokens you can use
Token Description %ADMIN% The administrator account email address used by the Policy Engine.
%AREANAME% The name of the message area containing the message.
%DATE% The date the original message was sent.
%DETECTED% Items detected by the What To Look For? clauses in invoked content rules.
%LOCALDATE% The date the original message was sent, shown in the Gateway's local timezone.
%POLICY% A list of the content rules invoked on the message.
%PRIMARYTHREATS% The threat type and name detected in a message. The values are separated by a colon, for example, VIRUS:EICAR.
%RCPTS% A list of the recipients. (This is a concatenated list of all the "Recipient" responses.)
%SENDER% The email address of the sender of the original message.
%SERVER% The Gateway server email address.
%SUBJECT% The subject of the original message.
%UNIQUEID% The Mail ID: a unique ID the Gateway assigns to a message.
- Click Save.
- Apply the configuration.
| If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information.If you use Peer Gateways (i.e. when multiple Gateways are peered), any configuration changes from a local Gateway can then be applied to all the peers at the same time. See Peer Gateways for more information. |