Enabling and Disabling Commands
You can enable and disable Commands as needed, without deleting them. When you create a new Command, the Enable this command check box is selected on the Command Settings tab.
To enable or disable a Command
-
In the administration interface, connect to EFT and click the Server tab.
-
On the Server tab, expand the Site node for the Site that you want to configure, click Commands, and then click a Command in the tree. The Command's definition appears in the right pane on the Command Settings tab.
-
To disable the Command, clear the Enable this command check box, and then click Apply. When the Command is disabled, an x within a red circle appears over the Command's icon.
-
To enable the Command, select the Enable this command check box, and then click Apply. When the Command is enabled, the x within a red circle does not appear over the Command's icon.