Changing Condition Placement

When you have multiple Conditions, you can change the order by clicking them using the up/down arrows next to the Condition, at the bottom of the Rule Builder, or by using copy/paste. When a Condition is moved, the Condition and any actions inside of that Condition also move. If a Condition has an else statement under it, the else statement is also moved. This is because the Condition, any actions inside that Condition, and any attached Else clauses are considered a conditional block, and the entire block is moved.

Example:

Condition A

Action 1

Action 2

Condition B

Action 3

Click the Condition A down arrow ONCE, and Condition A and its child Actions are moved as a block:

Condition B

Action 3

Condition A

Action 1

Action 2

This same behavior does not apply when the Condition being moved is part of a compound Condition. To move one of the Conditions inside of a compound Condition down (or up), and, therefore, outside of that conditional block, you need to click on one of the Condition’s up/down arrows:

Condition C1 and C2

Action 1

Action 2

Condition C3

Action 3

To move C1 down, click on the down arrow to the right of C1:

Condition C2

Action 1

Action 2

Condition C1

Condition C3

Action 3

To move a compound Condition, you need to select the ENTIRE Condition by clicking and dragging the Condition icon at the far left of the Condition, or select the line and then click the blue down arrow at the bottom of the dialog box (not the down arrow to the right of the Condition). A page icon appears if you drag it to an applicable location.