Reject messages from the following

You can specify Address Lists of email addresses whose members you want to block from sending email through Secure Email Gateway.

If a member of a specified Address List attempts to send a message, Secure Email Gateway rejects it.

Block mail from specified Address Lists

  1. Ensure you have created Static Address Lists and/or LDAP Synchronized Address Lists of addresses you want to block from sending email.

  2. Navigate to Policy > Manage Policy Definition > SpamLogic Settings. The SpamLogic Settings page is displayed.

  3. Select the Spam Policy tab.

  4. In the Reject messages from the following panel, click Click here to change these settings. All the currently configured static and LDAP Synchronized Address Lists are displayed.

  5. Select the Address Lists whose members you want to block from sending email.

  6. Click Save.

 

If you change any configuration or policy settings, you must Apply Configuration for the new settings to take effect. You can do this either from the Changes Made panel, or System > Configuration > Apply Configuration. See Apply new configuration for more information.

If you use Peer Gateways (i.e. when multiple Gateways are peered), any configuration changes from a local Gateway can then be applied to all the peers at the same time. See Configure Peer Gateways for more information.