Job Where Used

The Job Where Used page gathers information about a job's group membership, dependencies, and prerequisites and displays it all on one page.

To view the Job Where Used page, clicktap Show Actions for the job and select Where Used.

Things to know and do:

ClickTap Refresh to refresh the information in the display.
If the selected job is a member of a group, it's listed under Group Membership. You can see the group name and group description.

See below for a description of the actions you can take on the group.
If the selected job has Dependent Jobs, they're listed in that section. A dependent job will react to a specific status from the selected. Another way of putting it is that the selected job is a prerequisite for the dependent job. On this page, you can see the dependent job's name and the status it will react to.

See below for a description of the actions you can take on a dependent job.
If the selected job has prerequisite jobs, they're listed under Prerequisites. The selected job will react to a specific status from its prerequisite. You can see the prerequisite job name, the prerequisite react to status that must be met, and group description. Prerequisites that have been met are green; those that haven't been met are red.

See below for a description of the actions you can take on a prerequisite job.

Actions you can take on a group:

ClickTap Show Actions for the group to display the menu. You'll have the following options:

Select Do Job Now to submit the group for execution.
Select Hold in Group to place the group on hold.
Select Override in Group to override the normal run schedule and apply an manual override at the group level. The page displays any override code that has been applied.
Select Remove Override in Group to remove a manual schedule override that has been applied at the group level.
Select Job Completion History to see the completion history for the group control job.
Select Where Used to see where this group control job is used.
Select Properties to display the group control job's properties.

Actions you can take on a dependent job:

ClickTap Show Actions for any dependent job to display the menu. You'll have the following options:

Actions you can take on a prerequisite job:

ClickTap Show Actions for any prerequisite job to display the menu. You'll have the following options:

Select Insert Status to change the status of the prerequisite job so the selected reactive job can run.
Select Job Completion History to see the completion history for the prerequisite job.
Select Where Used to see where this prerequisite job is used.
Select Properties to display the prerequisite job's properties.