Faults Dashboard Widget

For the selected node, this widget displays the information from both the Database Faults and Non-Database Faults dashboard widgets in one place. So, it shows both the number of database faults and the number of non-database faults that occurred over a period of time. Database faults are against pages containing either database data or access paths. Non-database faults are against pages other than those designated as database pages. The rate for both is shown in page faults per second.

Faults database widget

Things you can do:

ClickTap Image of the Maximize button. Maximize to view the widget full-screen. ClickTap Image of the Close button with an X on it. X to view it on the dashboard again.

If the data is in a graph:

  • Hover your mouse overTouch and hold the lines or bars to view information about the data.

  • ClickTap a data point or bar to view the Performance Details page for it.

  • ClickTap any item in the legend to hide or show its data in the graph.

If the data is in a table:

To change the settings:

  1. ClickTapSettings button Settings on the widget.

  2. Type a new Name, if necessary.

  3. ClickTap Reset Name to have the software create a name based on the widget and the settings you've selected.

    Note: If you change any of the settings on this page and you're using the system-generated widget name, be sure to click Reset Name before saving your changes.

  4. Select the display Size of the widget on the dashboard. This affects the height of the widget.

  5. ClickTap the Auto-Refresh button to enable it (Yes) or disable it (No).

  6. Type the number of minutes to wait between each Auto-Refresh (Mins).

    Note: If a dashboard is displayed and you step away from your screen, as long as the time you enter here is less than what the Robot Network for Insite administrator enters for the Session Timeout, your session will not time out.

  7. ClickTap the Non-Database Faults and the Database Faults buttons to specify whether to display that data (Yes) or not (No).

  8. Select Graph or Table for the data display.

  9. ClickTap Look Up to select the system you want.

  10. ClickTap Save.

Note:ClickTap Delete to delete this widget from the dashboard.